Back in 1982 I was a newlywed and setting up a shop in the basement of our first home. My income wasn’t all that great, so I was on a tight budget.
At that point in time, I was a subscriber to Woodsmith magazine. In issues 20 and 22 of that year they published plans for a router table and stand. I don’t have a photo, but I drew up a SketchUp model you can see and download here:
It’s made from a few 2×4’s, ¾” plywood, and hardboard. It has served me well all these years.
Some time ago, I added a new 1″-thick laminated top to the router table. I didn’t even bother to remove the old top. But lately, the clear acrylic insert plate was showing signs of sagging.
So I decided it was time to give this old router table a little more attention. I started by removing both tops and discarding the original top. Next, I cut out the recess to fit a larger Kreg insert plate. I used Kreg’s insert plate levelers. They’re easy to install and it means I don’t need to create a rabbeted opening for the insert plate.
With the insert plate fitted, I turned the top upside down and added a 3″-wide apron at the front and back. Finally, I added a short rail at each end to engage the top of the legs of the router table base. I redrilled pilot holes and installed the original lag screws to hold the top in place.
Now I’m back in business and will find out soon how much of an improvement this will be over my old setup.